Faxback NET SatisFAXtion 8.7 (Including R3) - Manual Manuel d'utilisateur télécharger pdf (Page 202)

4 – Appendices

NET SatisFAXtion 8.7 Manual

202

fax_driver_name [string]: Device name that will override the key name that is

used for the fax device name. This needs to match a key or fax_device_name

from the driver specified by fax_driver_name. This would really only need to be

different when using the device# key name ordering option of ICANFax. For-

mat: One of the following values:

BOS_MAN

BT_MAN

CLASS1

CLASS2

GAMMAFAX

IP_FAX

PLUGIN_FAX_W32

SATISFAX

mode [string]: Sets whether this device sends, receives, both, or neither. This

setting must be present. When the application specifies "*" for "first available"

device when sending a message, devices set to FAX_OUT only have higher priori-

ty than devices set to FAX_IN, FAX_OUT. This is to prevent devices that are set

to both send and receive from sending a message, thus being unavailable for re-

ceives, when a device set to only send is available. This is a device specific set-

ting, but you can set the default for all devices by specifying this under the

global ICANFax section. Format: Comma separated list of FAX_IN and

FAX_OUT, or disabled. Default: FAX_IN, FAX_OUT.

4.2.1.2 Class1 Global

frs_20_timeout_msecs [dword 0–65535]: How many milliseconds to wait

for AT+FRS=20 to complete. This only applies if the software_frs_20_msecs =

0. Default: 500.

fts_8_timeout_msecs [dword 0–65535]: How many milliseconds to wait for

AT+FTS=8 to complete. Default: 500.

no_frame_checksum [boolean]: If true then modem will not return CRC

checksums in receive T30 frames. There was once a modem (AT&T Paradyne?)

that would not report the 2 CRC bytes for received T.30 frames (at+frh=3).

This lack of CRC bytes could cause the driver grief in knowing how much data

to actually process in the frame (i.e. receive CSI would lose 2 chars because the

driver assumes the last 2 bytes are CRC bytes). Default: false.

pause_before_frh_msecs [dword 0–65535]: Some modems would not be

able to understand the AT+FRH=3 command if a slight pause is not inserted fol-

lowing a previous response or command. Since this is usually a very small delay,

this was previously implemented in 16 bit as a software timing loop because

one clock tick (54ms) was too long to wait. NT has a min of 10ms clock inter-

rupt timing, so this may cause problems and the driver may need to be modified

to use a software delay timing loop. Default: 20.

receive_frame_response_timeout_msecs [dword 0–65535]: How long to

wait for modem response (OK, +FCERROR, NO CARRIER...) after receiving a

DLE/ETX terminated frame. Default: 3000.

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 237 238

Commentaires sur ces manuels

Pas de commentaire

Faxback NET SatisFAXtion 8.7 (Including R3) - Manual Manuel d'utilisateur Page 202

Commentaires sur ces manuels

Produits connexes et manuels pour Logiciel Faxback NET SatisFAXtion 8.7 (Including R3) - Manual