Faxback NET SatisFAXtion 8.6 - Manual Manuel d'utilisateur télécharger pdf (Page 227)

4 – Appendices NET SatisFAXtion 8.6 Manual 227

only those rates you list. On receiving, set the fastest and slowest rates; the

modem will allow those and any in between. Format: Comma separated list of

14400, 12000, 9600, 7200, 4800 and 2400. Default:

14400,12000,9600,7200,4800,2400.

allowed_send_baud_rates [string]: This setting constrains a modem to use

only certain baud rates. Use this to block a modem from using a rate or rates

that it supports, but are unreliable in your environment or are undesirable for

some other reason. On transmitting, use this as a mask; the modem will use

only those rates you list. On receiving, set the fastest and slowest rates; the

modem will allow those and any in between. Format: Comma separated list of

14400, 12000, 9600, 7200, 4800 and 2400. Default:

14400,12000,9600,7200,4800,2400.

carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or

“answering” states for a carrier from the remote device before hanging up.

Default: 45.

csid [string(20)]: The CSI for receive and the TSI for send.

dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state

before hanging up. Default: 45.

fax_device_name [string]: Optional device name that will override the key

name that is used for the fax device name. Typically this is never used. Format:

Up to 32 characters.

phone_number [string]: Specifies a value that the IP fax driver sets in the

From: header of SIP messages that it creates, identifying the IP fax port. A VoIP

router can, if so configured, pass along this value as the caller ID (ANI) for the

outbound fax call.

4.2.1.6 DotFax Plugin

rings_before_answer [dword 0–255]: Number of rings before modem

accepts call. Default: 1

send_por t_count [dword 0–65535]: Number of send-only ports to configure.

send_receive_por t_count [dword 0–65535]: Number of send/receive ports

to configure.

receive_por t_count [dword 0–65535]: Number of receive-only ports to

configure.

csid [string(20)]: The CSI for receive and the TSI for send.

4.2.1.7 Administration

Configuration key for the Administration program.

BillingCodeManager [string]: Path to BillingCodeManager.exe.

Repor ting [string]: Path to Reports.exe.

4.2.1.7.1 Loader

(Default) [string]: Resource.dll offset.

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 239 240

Pas de commentaire

Faxback NET SatisFAXtion 8.6 - Manual Manuel d'utilisateur Page 227